If you look at the side of the transmission, you will see two plugs that look the same. But one will be towards the bottom real low, that will be the drain plug. The higher plug will be the fill plug and it will be 4-5 inches above the lower plug.
To convert a 1992 Chevy Beretta from automatic to manual transmission, you'll need to gather a compatible manual transmission, clutch assembly, pedals, and necessary linkage. Begin by removing the automatic transmission and associated components, then install the manual transmission along with the clutch pedal and master/slave cylinder. Modify or replace the wiring harness if needed, and ensure the driveshaft and mounts are compatible. Finally, fill the manual transmission with the appropriate fluid and test the system before driving.
Synchromesh Manual Transmission Fluid
Not unless the 1992 is 4x4.
That would be the 4L60E
Manual transmission = 2.5 u.s. qts. Auto transmission = 3.3 u.s. qts. source = 1992 Toyota Paseo repair manual
There is normally a plug on the upper side of the transmission under the vehicle. That is where you add oil. Add oil until it runs out. It is then full.
No turbo 350's in 1992.
75w90
You can check your automatic transmission fluid in your 1992 Chevy Cavalier with the transmission dipstick. The dipstick will have marks that indicate whether it is full or low one quart.
YES BOLT ON .THEY ARE THE SAME 1992 TO 2002 FOR A MANUAL
It is a 4L60E
That would be the 4L80E