0
it should be on top of the engine on the passenger side.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
What is code 43 1992 Chevy S10 blazer?
knock sensor
Gm scanner found code 43 on 86 s10 blazer referring to electronic spark timing ESC circuit - low voltage detected or electronic spark control circuit problems what and where is this and how to fix?
I have a 92 s10 blazer and my code 43 was fixed by replacing the knock sensor. so maybe check the knock sensor and the wiring from that to the ECM.
What standard trans fits a 98 S10 Blazer 4x4 with a 43?
any from 88 to 98
What is a code 43 on a 1993 s-10 blazer?
knock sensor
Where does the small wire on the solenoid originate from on a 1992 S10 Blazer 43?
probably the ignition switch if you are refering to the starter solenoid.
Where can you find a schematic for the ignition control module of a 43 vortec engine in a 1994 Chevy Blazer S10?
Owners manual, positive.
What is a code 43 on a 93 Chevy blazer?
ESC / Electronic Spark Controll Circuit. and the knock sensor signal.
Could a faulty O2 sensor make a 98 Chevy S10 43 liter engine light come on with a 420 code catalytic converter operating under threshold and if so where is it?
no you need the catalytic converter replaced or removed but the o2 has a code of its own which it is P0141 and says the sensor is malfunctioning
1989 cheevy blazer 43 Ecm code 12?
System Normal
Why would a 1988 Chevy Blazer S10 with a 43 engine 6 cylinder shake?
it might be a broken motor mount. there are two mounts located towards the bottom of the left and right side of the engine make sure you are getting spark to all cylinders. (check for Misfiring)
Where is o2 sensor on a 1993 Chevrolet s 10 blazer with 43 v6?
There is 2 on that engine and both of them are screwed into the exhaust pipes up close were they bolt to the engine. They will be about 3 to 4 inches long with an elctric wire coming from them.
Why won't your engine stay on For a 1991 Chevy Blazer S10 43 liter engine?
My 94 blazer had this problem and it was the fuel pump. My Blazer eould start and run for a few seconds and the die,after Ichanged the fuel pump it started reigt up. . Awhile back my truck wasnt staying started for more then five seconds, and it turned out that it needed the RPMs adjusted bc it wasnt high enough to keep the truck going =( didnt cost much though
