answersLogoWhite

0

knock sensor

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

What is code 43 1992 Chevy S10 blazer?

knock sensor


Gm scanner found code 43 on 86 s10 blazer referring to electronic spark timing ESC circuit - low voltage detected or electronic spark control circuit problems what and where is this and how to fix?

I have a 92 s10 blazer and my code 43 was fixed by replacing the knock sensor. so maybe check the knock sensor and the wiring from that to the ECM.


What standard trans fits a 98 S10 Blazer 4x4 with a 43?

any from 88 to 98


Where does the small wire on the solenoid originate from on a 1992 S10 Blazer 43?

probably the ignition switch if you are refering to the starter solenoid.


Where can you find a schematic for the ignition control module of a 43 vortec engine in a 1994 Chevy Blazer S10?

Owners manual, positive.


1989 cheevy blazer 43 Ecm code 12?

System Normal


What is a code 43 on a 93 Chevy blazer?

ESC / Electronic Spark Controll Circuit. and the knock sensor signal.


Why would a 1988 Chevy Blazer S10 with a 43 engine 6 cylinder shake?

it might be a broken motor mount. there are two mounts located towards the bottom of the left and right side of the engine make sure you are getting spark to all cylinders. (check for Misfiring)


What are the release dates for John and Leeza from Hollywood - 1993 1-43?

John and Leeza from Hollywood - 1993 1-43 was released on: USA: 11 August 1993


Why won't your engine stay on For a 1991 Chevy Blazer S10 43 liter engine?

My 94 blazer had this problem and it was the fuel pump. My Blazer eould start and run for a few seconds and the die,after Ichanged the fuel pump it started reigt up. . Awhile back my truck wasnt staying started for more then five seconds, and it turned out that it needed the RPMs adjusted bc it wasnt high enough to keep the truck going =( didnt cost much though


Where is o2 sensor on a 1993 Chevrolet s 10 blazer with 43 v6?

There is 2 on that engine and both of them are screwed into the exhaust pipes up close were they bolt to the engine. They will be about 3 to 4 inches long with an elctric wire coming from them.


What does a code 43 on a 1990 Honda accord mean?

Code 43 is a problem in the fuel delivery system.