Firewall, driver's side.
There is a switch that gets engaged when you press in the clutch pedal. It's located just below the clutch master cylinder.
With the 3 speed manual trans, 99 mph.With the 4 speed manual trans, 97 mph.
With the 3 speed manual trans, 83 mph.With the 4 speed manual trans, 90 mph.
6.8 pints of 75W-90 Manual Trans Gear Lube.
With 3 speed manual trans, 78 mph.With 4 speed manual trans, 81 mph.
A lot. Obviously the manual tranny, ull also need the clutch pedal, a new brake master cylinder since the manuals uses the same container as the brakes. Mit need new drive shafts not sure A lot. Obviously the manual tranny, ull also need the clutch pedal, a new brake master cylinder since the manuals uses the same container as the brakes. Mit need new drive shafts not sure
If you need to replace the slave cylinder it is located in the bell housing and the trans has to be removed. The clutch master cylinder is located on the firewall on the drivers side
Relay is in underhood fuse block marked A trans
check for leakage from trans master cylinder to slave cylinder at bellhousing. other things. ?? worn synchronizer gears / worn clutch
Is it an automatic or manual transmission? If its a manual trans its under the clutch pedal.
Usually not Usually a plug at the side of the transmission - fill to this level
There is no bleed screw on the 3.4 clutch. You have to unbolt the slave cylinder from the trans and drop it down so that it and the line are lower than the master cylinder, then pump the piston in/out to force any trapped air up to the master cylinder.