0
What else can I help you with?
Where is the trunk release on a 1993 buick regal custom?
Glove box
Where is the coolant temperature sensor located on a 1992 Buick Regal with a 3.1 engine?
On a 1993 buick regal it is on the side of the radiator.
Where is the PCV valve on a 1993 Buick Regal 3.1L?
On a 1993 Buick Regal 3.1L, the PCV valve is located on the intake manifold. It is situated underneath the MAP sensor.
What is faster a mustang 5.0 or a 1993 buick custom regal 3.8 l?
a mustang 5.0
Where is the coolant temp sensor for a 1992 Buick regal with a 3.1 engine?
On a 1993 buick regal it is on the passager side of the radiator. Hope this helps
Why does my 1993 Buick regal crank but doesn't start?
could be the crank sensor, the go out. the have a reputation for that.
What would be the problem if the powers lock mirrors and interior lights weren't working in a 1993 Buick Regal Custom?
newdiv
How do you change the alternator on a 1993 Buick regal custom?
you loosen the bolts on the opposite sides of it. then, you change the alternater, and tighten the bolts.
Where is the fuel pump relay on a 1993 Buick Regal Custom?
Inside the fuel tank, below the rear seat on the passenger side of the vehicle.
What is the fuse box layout on a 93 Buick Regal Custom?
The fuse box layout can be found under the cover of a 1993 Buick Regal. There will be a stick underneath the fuse box labeling each fuse and their primary function.
Where is temperature sensor on a 1993 Buick Regal 3.8L?
On a 1993 Buick Regal with a 3.8L engine, the temperature sensor, also known as the coolant temperature sensor, is typically located near the engine block, on the intake manifold. It is usually positioned close to the thermostat housing or cylinder head. To access it, you may need to remove some engine covers or components, depending on the specific layout of your engine.
How do you remove the oil level sensor from the wired connector 1993 Buick Regal custom 3800 auto?
This was my question and can I pull the connector straight without breaking it does it have a lock cannot see up close using mirrors and magifine glass. Need to do quick so I can replace my starter. Thanks
