Chevy Camaro Z28

Where is the oil pressure sensor on a 1997 z28 camaro?

123

Top Answer
User Avatar
Wiki User
Answered
2012-08-16 03:47:19
2012-08-16 03:47:19

Its in under the alternator and next to the oul filter

001
๐Ÿ˜‚
0
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Related Questions


yes it does- it is to the right of the oil filter.


where the oil pressure sensor located on 1997 Honda Civic EX 1.6L


The oil pressure sensor on a 1997 V8 is on the top rear of the engine next to the distributor.


The oil pressure sensor could be defective as they can be clogged over time. You can use an oil stabilizer or replace the sensor if the oil stabilizer does not fix it.


Check fuse, relay and oil pressure sensor. In these cars this sensor will cut the fuel pump to save your motor if it reads too low oil pressure.


most small blick chevys have the oil sensor on the back of the motor behind the intake just right of the distributor



Oil pressure is low, oil pressure sensor has failedOil pressure is low, oil pressure sensor has failed


If it is a 1997 S10 4.3, with the engine running, remove the fuel pump relay, if the engines stops running, the oil pressure sensor is bad.


Low oil, low oil pressure, failed oil pressure sensor.Low oil, low oil pressure, failed oil pressure sensor.



On the driver's side next to the distributor; hard to get to.


Back of the engine, next to the distributor


On the back of the engine, next to the distributor.


It is right next to the oil filter


Sensor is located on the drivers side of the oil pan.


No, a defective oil pressure sensor will not harm the engine as long as the oil pressure is what it should be. However, how do you know what the pressure is if the sensor is bad. Replace the sensor so that you can receive a warning if the oil pressure drops below what is optimum.


The 1995 Nissan Pathfinder oil pressure sensor can be found next to the oil filter. The oil pressure sensor measures the oil pressure in the engine.


An oil pressure sensor socket.An oil pressure sensor socket.


The oil pressure sensor sends a reading to the gauge so you can moniter the engine's oil pressure. No oil pressure means the engine is in big trouble.



The oil pressure switch on a 90 Chevy Camaro is located on the bottom of the engine near the oil filter. It constantly monitors the function and output of the oil pump.


the knock sensor on a 91 camaro 305 in on the passenger side of the block, bellow the exhaust manifold. its a few inches in front of the bell housing., and has a single wire running to it. looks a bit like a temp sensor, or oil pressure sensor.


The oil pressure switch on a 1989 Chevy Camaro RS is located on the bottom of the engine hear the oil filter. It constantly monitors oil pressure and updates the computer on its status.


The oil pressure sensor is on the front of the engine, near the oil filter.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.