answersLogoWhite

0

You never said whether you had the Cummins or the MaxxForce engine. On the Cummins, it's on the left side of the engine block, about 1/3 of the way up from the rear of the engine. The MaxxForce, I'm not familiar enough with to know offhand, but it's likely to be situated in a similar location. If it is a Cummins, you'll need a 1-1/8" deep socket, wobble extension is preferable, possibly a swivel (if you have a pre-2012 model, you have the dual suspended canister fuel filters, and the oil sending unit is located behind the primary fuel filter... using a swivel and wobble socket is very helpful if you don't want to remove the primary fuel filter or go through the hassle of removing the side skirts), and a small slotted screwdriver.

User Avatar

Wiki User

10y ago

What else can I help you with?

Related Questions

What does the ambient temperature sensor look like on a international prostar?

The ambient temperature sensor on an International ProStar truck is typically a small, cylindrical device that is mounted near the front of the vehicle, often behind the grille or in a location exposed to outside air. It usually has a plastic or metal housing and may feature electrical connectors for wiring. The sensor is designed to measure the outside air temperature to provide accurate readings for the vehicle's climate control and engine management systems. Its appearance can vary slightly depending on the model year and specific configuration of the truck.


What does modular 42 mean for a 2013 international prostar truck?

Module 42 is the ABS system. If you're getting that message on the dash, there's a fault somewhere... faulty wheel speed sensor is the most common cause of this.


What are the Advantages of pressure sensor?

what is advantages of pressure sensor?


Where dos a premium oxygen sensor go in a 1994 jet- ta?

where dos the premium oxygen sensor go in a 1994 jet-ta L.S 0.2


Where is the exhaust back pressure sensor on a international 2005 dt466?

On a 2005 International DT466, the exhaust back pressure sensor is typically located on the exhaust manifold. It is mounted on the top or side of the manifold, where it can measure the pressure of the exhaust gases. To access it, you may need to remove some surrounding components for better visibility and ease of replacement. Always refer to the vehicle's service manual for specific details and location.


What does a pump pressure sensor do?

The fuel pump pressure sensor monitors the fuel pressure of the vehicle.


What does a fuel pump pressure sensor do?

The fuel pump pressure sensor monitors the fuel pressure of the vehicle.


Where is fuel pressure sensor on 98 ford windstar?

There is no fuel pressure sensor.


What does the differential pressure sensor do?

It's the MAP sensor...Manifold Absolute Pressure.


Where is the exterior temperature sensor for a 2012 prostar?

Not 100% certain about this model, but ambient air temperature sensors are usually a probe which sticks out through the bottom of the mirror housing on the left side of the vehicle.


What is a delta pressure sensor?

It is a slang tern given to a Differential Pressure Sensor or Transducer.


Why does your oil light keep coming on your 2002 pt cruiser?

Oil pressure is low, oil pressure sensor has failedOil pressure is low, oil pressure sensor has failed