0
On a 2005 International DT466, the exhaust back pressure sensor is typically located on the exhaust manifold. It is mounted on the top or side of the manifold, where it can measure the pressure of the exhaust gases. To access it, you may need to remove some surrounding components for better visibility and ease of replacement. Always refer to the vehicle's service manual for specific details and location.
What else can I help you with?
How do you raise the speed limiter on a 2006 international 4300 dt466 without going to the dealer?
Disrupt the frequency of the signal from the speed sensor to the ECM.
What is the dt in dt466 stand for?
The "DT" in DT466 stands for "Diesel Turbocharged." It is a type of diesel engine manufactured by International Harvester and later by Navistar International.
Where is the crankshaft sensor located at on a 2003 internationl dt466?
On the engine.
Where MAP sensor located on a 2003 International 4300 truck?
It depends on what engine you have. I have the Dt466 engine in mine and my MAP sensor is located on top of the valve cover towards the front of the engine it has a three prong pigtail on it.
What is the oil capacity for a 2004 international 4300 dt466?
29 quarts
How much does a International DT466 engine weigh?
A little over 1400 lbs
What are the torque specs for an international dt466 main cap?
115 ft pounds
How many miles per gallon does 2001 international dt466 get?
I have the DT466 in a 24' van. Use it lightly loaded, normally about 8000 pounds tops, and we get 9 MPG.
What is international dt466?
DT466 is an inline six cylinder diesel motor manufactured by Navistar International. It's a 7.6 litre (466 cubic inch) motor, rated between 210 and 300 horsepower. It was superseded by the DT466E in 1994, which introduced electronic controls to the motor, although the badges on the side of International vehicles did not reflect this change, and still simply said "DT466". As of 2007, the DT466 was redesigned to meet the 2007 emissions regulations, and is now produced and marketed as the MaxxForce DT.
Repair manuel for a 1994 international dt466?
repair manuals for a 2001 international dt 466e model c195
What is the oil capacity for a 1995 International 4700 DT466?
The oil capacity for a 1995 International 4700 with a DT466 engine is approximately 12 quarts (or about 11.4 liters) when including the oil filter. It's important to check the owner's manual for specific recommendations and to ensure accurate measurements during oil changes.
What is the oil capacity of a 1991 international 4900 with a DT466?
The oil capacity of a 1991 International 4900 equipped with a DT466 engine is approximately 12 quarts (or about 11.4 liters) when including the oil filter. It's always advisable to refer to the owner's manual for the most accurate specifications and to ensure proper maintenance.
