0
What else can I help you with?
Where MAP sensor located on a 2003 International 4300 truck?
It depends on what engine you have. I have the Dt466 engine in mine and my MAP sensor is located on top of the valve cover towards the front of the engine it has a three prong pigtail on it.
Where is the exhaust back pressure sensor on a international 2005 dt466?
On a 2005 International DT466, the exhaust back pressure sensor is typically located on the exhaust manifold. It is mounted on the top or side of the manifold, where it can measure the pressure of the exhaust gases. To access it, you may need to remove some surrounding components for better visibility and ease of replacement. Always refer to the vehicle's service manual for specific details and location.
How do you raise the speed limiter on a 2006 international 4300 dt466 without going to the dealer?
Disrupt the frequency of the signal from the speed sensor to the ECM.
What is code 335 on dt466?
nothing
What is the dt in dt466 stand for?
The "DT" in DT466 stands for "Diesel Turbocharged." It is a type of diesel engine manufactured by International Harvester and later by Navistar International.
How do you remove crank pulley dt466?
To remove the crank pulley on a DT466 engine, first disconnect the battery and remove any accessories obstructing access to the pulley. Use a suitable puller to ensure even pressure while removing the pulley from the crankshaft. If the pulley is stuck, applying heat or penetrating oil may help loosen it. Finally, ensure all bolts are removed, and take care to support the engine properly during the process.
How many miles per gallon does 2001 international dt466 get?
I have the DT466 in a 24' van. Use it lightly loaded, normally about 8000 pounds tops, and we get 9 MPG.
What is international dt466?
DT466 is an inline six cylinder diesel motor manufactured by Navistar International. It's a 7.6 litre (466 cubic inch) motor, rated between 210 and 300 horsepower. It was superseded by the DT466E in 1994, which introduced electronic controls to the motor, although the badges on the side of International vehicles did not reflect this change, and still simply said "DT466". As of 2007, the DT466 was redesigned to meet the 2007 emissions regulations, and is now produced and marketed as the MaxxForce DT.
What is the oil capacity for a 2004 international 4300 dt466?
29 quarts
Where is the fuel shutoff fuse on a DT466?
The fuel stop solenoids on a DT466 are actually three wire types. There is a ground wire, a pull-in wire, and an ignition wire. It will be on the main engine harness just above the pump.
How much does a International DT466 engine weigh?
A little over 1400 lbs
What are the torque specs for an international dt466 main cap?
115 ft pounds
