Oil and Oil Filters
Ford Expedition
Ford Expedition XLT
Ford F-250

Where is the oil sending unit on a 2000 Ford Expedition?

757677

Top Answer
User Avatar
Wiki User
2005-03-28 17:57:29
2005-03-28 17:57:29

Front surface of driver side head

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Temperature Gauge Sending Unit The sending unit is located in the front section of the manifold in the vicinity of the thermostat.

User Avatar

Inside the fuel tank with the sending unit for your fuel gauge

User Avatar

Temperature Gauge Sending Unit The sending unit is located in the front section of the intake manifold in the vicinity of the thermostat.

User Avatar

Are you referring to the Temperature Gauge Sending Unit if so The sending unit is located in the front section of the manifold in the vicinity of the thermostat.

User Avatar

Temperature Gauge Sending Unit The sending unit is located in the front section of the intake manifold in the vicinity of the thermostat.

User Avatar

Temperature Gauge Sending Unit The sending unit is located in the front section of the manifold in the vicinity of the thermostat.

User Avatar

You would have to call your local parts store for prices. Temperature Gauge Sending Unit The sending unit is located in the front section of the manifold in the vicinity of the thermostat.

User Avatar

Where is the oil pressure sending unit on 1992 ford ranger

User Avatar

Where is the oil sending unit on ford freestar

User Avatar

Where is the oil sending unit on a 2000 dodge neon?

User Avatar

On a 2000 Ford Ranger : If you happen to have the 4.0 liter EFI , V6 engine : The oil pressure sending unit for the dash gauge is located on the drivers side of the engine , below the power steering pump

User Avatar

Do you mean the Temp sending unit, oil pressure sending unit, or fuel level sending unit?

User Avatar

All fuel sending units are located in the fuel tank.

User Avatar

wher is the oil sending unit for a 1999 ford f250 v10 triten located on moter

User Avatar

Any sensor that sends information to the computer or driver, such as fuel sending unit, oil pressure sending unit, etc.

User Avatar

The temperature sending unit on a Ford V10 gas 6.8 liter is on the front of the cylinder head. It is a true sending unit and not just an on and off switch.

User Avatar

what kind of sending unit is it? fuel?,oil pressure?

User Avatar

The oil pressure sending unit on a 302 ford is located on the block of the engine. It screws into the block and the sending unit goes on the end. The oil pressure sending unit on a 302 Ford is slightly above and to the left of the oil filter. I find it is easier to replace with the oil filter out.

User Avatar

where is the temp. sending unit located on a 1999 ford ranger xlt 6cyl 3.0l .Gauge does not work.

User Avatar

On the drivers side of the engine below the power steering pump

User Avatar

The sending unit for the computer is on the drivers side right behind the distributor. The sending unit for the gauge in the cab is on the passenger side (both tap directly into the intake

User Avatar

The temperature sending unit on the 1999 Ford Taurus v6 is on the rear of the engine. It is closer to the driver side about 7 inches down.

User Avatar

the oil sending unit its right next to the dipstick and the oil filter on the ford 300 its a screw in device with a wire protruding from it.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.