answersLogoWhite

0

Are you referring to the Temperature Gauge Sending Unit if so The sending unit is located in the front section of the manifold in the vicinity of the thermostat.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

Why are auto lamps not working on a 2003 expedition?

Check fuses


Why are Heated and cool seats not working 2003 expedition?

check fuses


How do you check if the ABS sensor is working on a 1999 Ford Expedition What can you do?

how do you check the abs sensor on a 1998 contour


Why are my Rear window vents not working in my 1999 Ford Expedition Eddie Bauer?

check fuses


How do you fix the problem of a 97 expedition brake lights not working but all other lights are working?

Check the brake light bulbs, Check the brake light fuse, Check the brake light switch, In that order.


How do you check if the heated seat is working on a 2000 ford expedition Eddie Bauer?

It's simple. Sit in the seat turn the ignition to ON, and turn the seat heater control to ON. Then wait a few minutes and it the heater is working you should feel a warm sensation where your legs and butt contact the seat.


Which fuse operates the fan speed control on 200 ford expedition?

Check Owner's Manual. If you do not have one. Check Related links below. check under fuses


When does the check gauge light come on in a 2006 ford expedition?

According to the 2006 Ford Expedition Owner Guide : The " CHECK GAGE " light comes on if the engine coolant temperature is HIGH or the engine oil pressure is LOW


Why is there no cold water in the shower, but the sinks are working fine?

The lack of cold water in the shower could be due to a problem with the shower's plumbing or temperature control mechanism. This issue may not affect the sinks if they have separate plumbing systems. It is recommended to check the shower's plumbing and temperature control to identify and fix the problem.


What should you check for when cruise control isn't working on a 1995 Chrysler Grand Voyager?

check the fuse.


Why are your Expedition power door locks are making a grinding noise?

The expedition door lock relay could be stuck causing the grinding noise. Check to insure that the lock relay is working properly.


How do you fix a 1998 Chevy Blazer that only blows hot air out of the AC?

Check to see if compressor is working - if not may be a bad fuse (at the compressor) or low refrigerant charge Make sure temperature control is working and is set to "cool" position

Trending Questions
Does parts from a 1970 Pontiac 455 engine bolt onto a 1976 Pontiac Engine like heads and manifolds? What kind of engine does a Ford Fiesta use? Do they make a fuel injection kit for your 1985 cj7 4 cylinder engine? How do you change drive belt on a 6.0L ford? Does the 2004 Chrysler Town and Country have a cabin air filter? What is the fuel tank capacity for a 1999 Chevy Suburban? Where is the air bag fuse or relay on a 99 Ford Ranger? Will a bad blower resistor cause the Day Lights to shut off when the blower is turned on on a 2001 Grand Prix? Why does your 5.7 Chevy misfire on no1 cylinder? Why does white smoke come out exhaust on 84 Chevy pickup over heat? On the gm 5.7l v8 engine vin k where are the map and iac sensors located? 2002 Galant that has an idle problem when you are at a stop the idle goes up and down sometimes to the point of engine shut off your question is does anyone know how to corrrect this issue? How much would a major tuneup be on SUV? Where is the thermostat located on a 1994 Ford Tempo? Where is the starter located on an 1987 Mazda rx7 manual? Where can one get after market fuel lines with Chevy fittings for a '97 Silverado 1500? What size is the front wheel hub bearing nut on a 95 gmc sonoma 4x4? When I changed rear pads and rotors on 2001 S10 blazer I lubed all the pins and the brakes seem to be to tight and smell hot after test drive is this normal? How do you remove rear speakers in alero 2004? Where is the number 1 cylinder located 2000 camaro 5.7L engine?