Bank 1 should be the side of the engine cylinder #1 is on.
where is the oxygen sensor in a 1995 gmc jimmy
there is one after the cat converter and there is an intake sensor in front of the motor.
where is the evap purge valve located in a 1996 jimmy
where it the temp sensor sender located on a 2001 gmc Jimmy
If you are replacing it with a new one, cut the wires off at the sensor so you can slip a 7/8" box wrench over it. It may take some pressure to break it loose but it will. Remember, lefty loosey, righty tighty. Also bank 1 sensor 1 would be the first sensor located on the drivers side exhaust after the engine.
2000 jimmy 4.3ltr v6. were is the o2 sensor bank 1, sensor 3
they're usually after the cat-con on the exhaust...
There are several and they are all mounted on the exhaust system.
fuel tank.
The crank sensor is located in front of the oil pan underneath the car.
water temperature sensor located near steering colum..
To change the camshaft positioning sensor on a 98 GMC Jimmy you need to first locate it. The sensor is located within the distributor. Next, unbolt the old sensor and replace with a new sensor.