Check the exhaust manifold.
It's threaded into the front of your exhaust manifold.
egr valve
rear of engine compartment near the bulkhead
Inside the distributor.
On a 1995 Geo Prizm, the oxygen sensor is typically located on the exhaust manifold, near the engine. There may also be a second oxygen sensor located further down the exhaust system, after the catalytic converter. It's important to check the specific engine configuration, as the placement can vary slightly depending on the engine type.
airbag sensor and iat sensor are not the same thing... wiki
air filter, oxygen sensor, sticking injector, plugs, EGR valve... What does the computer say?
IT'S CALLED A MASS AIR FLOW SENSOR AND IT'S LOCATED BETWEEN THE AIR CLEANER AND THE THROTTLE BODY..
It has 1 O2 sensor located on the exhaust manifold befor the catalytic converter
under he motor mount
It is possible as the signal from the oxygen sensor is sent to the computer
The oxygen sensor on a Geo Prizm is typically located in the exhaust system. There are usually two sensors: the upstream (pre-catalytic converter) sensor is found near the exhaust manifold, while the downstream (post-catalytic converter) sensor is located after the catalytic converter. To access them, you may need to lift the vehicle for better visibility and reach. Always refer to the vehicle's service manual for specific details and locations.