Oldsmobile Eighty-Eight
Oldsmobile Ninety-Eight
Chevy Camaro RS

Where is the pass-key module located on a 1992 Oldsmobile Eighty Eight?


Top Answer
User Avatar
Wiki User
2007-04-14 00:48:58
2007-04-14 00:48:58

in the dashboard,remove the glove box then it is just above the ecm.


Related Questions

it is located on the right side of the fuse panel behind the glove box.

The body control module, on your 1997 Oldsmobile, is located on the rear suspension. The module is mounted on the passenger side of the rear axle.

The 1999 Oldsmobile headlamp module is located on the firewall in the engine compartment. The headlamp module will be on the drivers side of the firewall.

There is none - usually it is the module in the top of the heater / blower box (resistor module) that is the problem.

remove the panel under the steering wheel and it should be located on the fire wall

The 2001 Oldsmobile Aurora turn signal/ hazard flasher module is located up under the LH dash above your feet.

under the ignition coils. it is flat comes off after you remove the three numbered igniton coils. they plug into the module underneath them.

The 1997 Oldsmobile airbag module sensor can be found below the dashboard on the drivers side. The airbag module should be labeled as such.

it is located above the gas pedal almost under the steering wheel

its attached to the distributor, right at the base, should have two electrical plugs going into it, one from the coil

Haven't looked at a newer GM, but the problem always used to be the cruise control, usually the short cable from the cruise module on the drivers side inside fender. Don't know if they still use the same system or not, but something to look at.

where is the ignition module located on a 1988 Mazda b2200

The 1998 Oldsmobile Intrigue turn signal flasher control module is below the dashboard on the drivers side of the passenger compartment. The signal flasher control module should be labeled as such.

module locatedwhere is the module on a 9 Chevy blazer

Under the maxifuse center on the firewall - directly in the top of the blower / heater assembly. You will need to remove the two screws that hold the fuse / relay box in place to get to the module.

In a 83 Oldsmobile you remove the dist cap, unplug and unscrew the module and install a new module. It would be helpful to know if this is your lawnmower or boat engine.

where is the ignition module located ina 2000 integra acura

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.