Chevy Camaro Z28

Where is the pcv valve on a 1993 Chevy Camaro Z28 350 5.7L?

192021

Top Answer
User Avatar
Wiki User
2007-06-29 22:23:50
2007-06-29 22:23:50

Most GM PCV valves connect to the rocker valve cover through a rubber seal. Under hood, center, upper engine area, mounted in rear of intake manifold

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

how do i doa Valve adjustments for a Chevy 350 5.7l?

User Avatar

Chevy didn't offer a 350 in an 86 Camaro, but if they did, it would theoretically work in an 87 Caprice.

User Avatar

What are the valveadjustment's on a 1990 iroc camaro with a 5.7 liter 350 motor

User Avatar

If you have a 305 or 350, it is 1,8,4,3,6,5,7,2.

User Avatar

yea it did chevy lt1 350 cubic inchs 275bhp

User Avatar

They didn't make a Chevy 350 in 1967. This answer is wrong... The 350 came in the 1967 Chevy Camaro SS350. http://en.wikipedia.org/wiki/Chevrolet_small-block_engine

User Avatar

The 350 sbc was introduced in the new for 1967 Chevrolet Camaro , it was rated at 295 hp .

User Avatar

The chevy 350 engines were produced in production models of Chevy between 1968 until 1998. It was used in several Chevy models such as Chevrolet Camaro and Chevrolet corvettes.

User Avatar

firing order chevy camaro z28 78 5.7

User Avatar

Yes it will. GM. put alot of V8 engines in that year camaro.

User Avatar

it is in one of the valve covers

User Avatar

how much torque for a Chevy Z71 350 vortec engine valve cover

User Avatar

AnswerThe spark plug gap is .035 on a 1993 GMC 350 TBI.

User Avatar

if you mean 4.3 then the answer is yes but you will have to change the brain (computer) to one out of a camaro that had a 350 alreadyand you will have to change the frame mounts and the wireing harness will still work but you will have to extend the alternator wire.hope that helps. You would be Putting Alot of power in that Chevy my father had a Chevy suberban custom 350 in it and wow that big rig moved fast!

User Avatar

You need to put a vent and a PCV valve in the valve covers.

User Avatar

The PCV valve on a 1992 Chevy 1500 350 is located on the intake manifold which is on the passenger side of the vehicle and to the right of the throttle. It has two bolts that hold it in place.

User Avatar

No, the 350 Vortec was not available until a couple years later.

User Avatar

Where is the ERG valve located on a Chevy Vandura 5.7 350 engine?

User Avatar

It will hold 5 QTS. with a new filter.

User Avatar

a 350 is a Chevy motor, if it doesnt work you will need to cut some parts out to make it fit haha


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.