under the hood....
The cap on the power steering reservoir will tell you what you require. ATF for BMW's without the self leveling suspension. If you do have a suspension system, then use Pentosin CHF 11S or CHF 7.1 or LHM.
In the Trunk.
its at the right, it says ATF only. that's it, you can pick some fluid up at an auto zone for around 3 dollars.
Look for a belt driven accessory. It should have a cap with attached stick & red fluid inside if not labeled. Add to fill mark,
upper timing cover
To add coolant to a 1998 BMW 740i, locate the coolant reservoir, which is typically found near the front of the engine bay on the driver's side. Remove the cap from the reservoir, and pour in the appropriate coolant mixture, ensuring you do not overfill it. Always check the engine temperature and allow it to cool before adding coolant to prevent any injuries or damage. After refilling, replace the cap securely.
how do i reset computer on 1995 bmw 740i
how do you change the clock ring on a 1995 BMW 740i
Have the same problem with a 635/csi. I'm not technically a mechanic, but, pretty sure it's the heater control valve.
The inertia switch on a 2000 BMW 740i is typically located in the trunk area, near the battery or behind the rear seat. It is designed to cut off fuel supply in the event of a collision. To access it, you might need to remove some trim pieces or the rear seat cushion. Always consult the owner's manual for specific instructions related to your vehicle.
no
In a 1997 BMW 740i, the LCM (Light Control Module) is typically located in the driver's footwell, behind the dashboard. To access it, you may need to remove the cover panel beneath the steering column. The LCM controls various lighting functions, including headlights and interior lights. If you need to troubleshoot or replace it, ensure the vehicle's battery is disconnected for safety.