picture of the fan relay for 1993 mercury topaz
there are 5 wires that go to the starter relay on a 1993 mercury topaz
Beside battery along inner fender.
I need to find out how to replace a fuel pump for a 1993 Mercury Topaz, 4 cylinder, fuel injection
need diagram of rear brake lines for 1993 mercury topaz
4 hot ground ignitor from comp/dist to pump
picture on how to replace a water pump for mercury topaz
The coolant temperature sensor on a 1993 Mercury Topaz is located at the rear of the engine. To get to it, you have to remove the driver side fan.
I also need to know how to install a alternator in a Mercury Topaz, but my car is a 1991. PLEASE HELP...
Yes. Not an acessory outlet.
IF anyone has any imfo on how best to replace an ignition system on a 1993 Mercury topaz please call 714-6383162, or e-mail me at KN657@yahoo.com
Should be just one.
Inside the fuel tank.
On a 1993 Mercury Topaz : Yes , both the 2.3 litre four cylinder engine and the 3.0 litre V6 engine use a timing CHAIN
the swwitch is on top of the transmission
when the belt has no slack in it
no but it does have a manual hot /cold lever control box which is adjusted via vacume hoses attached to the heater control unit on the dash
Horn's should be in the fender wells in the engine compartment.
They should be in the front fender well, in the engine compartment.
A 1993 Mercury belt diagram can be obtained from most Ford dealerships. The belt diagram can also be found at most auto-parts stores.
the computer box on a 1992 topaz is on the drivers side under the dashboard on the firewall behind the fuse panel to the left i would think a 1993 would be similar
it depends on whether your car is automatic or manual shift.
Most likely speedometer cable