A Chrysler Sebring does not have a reset switch.
The Hydraulic pump for 1997 to 2006 Chrysler Sebring convertible is located behind the back seat and center of the car on a small shelf.
behind the top rear seat
It is behind the rear seat back.
Above the gas tank
It is under the hood, between the engine and grill.
underneath the brake pedal
It is built inside the distributor on the 2.5L.
Behind the back seat
They are on the front, rear, and transmission side.
Inside of the drivers side fender well.
It is under the dash on the driver side.
Under the front passenger seat.
For a 1997 Sebring Convertible the oil dipstick is located just left of center towards the front of the car and should be labeled "engine".
It is behind the rear seat. You have to remove the seat to access.
On the 2.5L it is on the top rear of the bell housing.
They should be under the floor in the trunk, with the spare tire.
It is behind the engine mount on the radiator side of the engine.
Th horn is located behind the passenger front bumper, near the fog light.
The oil pan on the bottom is the fluid reservoir.
The convertable hydraulics are located behind the rear seat.
Oxygen sensors are screwed into the exhaust on both sides of the catalytic converter.
It is inside the black plastic housing under the hood, driver side.
It is behind the rear seat.It is behind the rear seat.
The shift solenoid B for a 1997 Chrysler Convertible is located inside the transmission. The speed sensor has to be removed to access the bolts to remove the cover over this shift solenoid.