A Chrysler Sebring does not have a reset switch.
The Hydraulic pump for 1997 to 2006 Chrysler Sebring convertible is located behind the back seat and center of the car on a small shelf.
behind the top rear seat
Above the gas tank
It is under the hood, between the engine and grill.
It is behind the rear seat back.
underneath the brake pedal
It is built inside the distributor on the 2.5L.
Behind the back seat
They are on the front, rear, and transmission side.
V6, it is under the housing where the lower radiator hose hooks to the engine. I4, under the housing where the upper radaitor hose hooks.
It is under the dash on the driver side.
Inside of the drivers side fender well.
Under the front passenger seat.
Follow the lower radiator hose to the engine and at that junction is the thermostat housing.
It is behind the rear seat.It is behind the rear seat.
The thermostat is located in the water inlet where the radiator hose connects from the radiator to the engine.
It is behind the rear seat. You have to remove the seat to access.
On the 2.5L it is on the top rear of the bell housing.
They should be under the floor in the trunk, with the spare tire.
It is behind the engine mount on the radiator side of the engine.
For a 1997 Sebring Convertible the oil dipstick is located just left of center towards the front of the car and should be labeled "engine".
Th horn is located behind the passenger front bumper, near the fog light.
On the 2.5L V6 the thermostat is located under the housing where the lower raditor hose is hooked the the engine.
The oil pan on the bottom is the fluid reservoir.