answersLogoWhite

0

Where is the radiator on Chevy Blazer?

Updated: 8/16/2019
User Avatar

Wiki User

16y ago

Best Answer

In the front

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where is the radiator on Chevy Blazer?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

1997 Chevy blazer radiator drain plug?

its in the fuel tank


Where is the outside temperature sensor on a 1997 Chevy Blazer?

It is in the front of the radiator area clipped to the radiator support.


Where is the radiator drain plug on a 1999 Chevy Blazer?

its on the left hand side of the radiator but not very easy to get to My apology, it is a 1996 S10 Chevy Blazer instead of a 1999 Chevy Blazer. I need to see a picture or more detail of where the drain plug is located on the left side of the radiator. I have searched and searched and cannot find anything to drain with. Thanks, Linel


How much radiator coolant does your 2001 Chevy blazer hold?

11.7 quarts


Where is the drain plug for the radiator on a 96 Chevy s-10 blazer located?

Should be at the bottom or rear of radiator


Where is radiator drain plug on 1995 Chevy Blazer?

It should be located just below the lower radiator hose.


Where is the thermostat on a 2001 Chevy Blazer?

follow the top radiator hose to the engine. It should be there.


Oil in radiator 2002 Chevy trail blazer?

You have a blown head gasket or a cracked head.


Where is the thermostat located on 1998 Chevy Blazer?

Should be in housing at the end of upper radiator hose


How do you change a radiator hose in a 1999 Chevy blazer?

Drain the radiator in the 1999 Blazer. Loosen the hose clamps at each end of the radiator hose. Gently twist the hose and pull the ends to break free. Replace with a new hose and clamps.


Where is the hood latch located on 1992 Chevy blazer s-10?

Front center of radiator support.


How do you flush a radiator on a Chevy Blazer?

Drain the blazer radiator. Refill with water. Open the heat on high, start the engine for a few minutes. Drain the system again Repeat this several times to get all of the old coolant out.