No, GM does not use inertia switches.
I would suggest looking in the trunk on your car for the fuel reset button. Its there somewhere. Thanks kissthisbunny43
A 1995 Jeep does not have a reset button.
A Chrysler LHS does not have a reset button.
Chrysler does not have reset buttons.
You reset the alarm by unlocking the doors with a key. A 1995 Jeep does not have a reset button.
No, it does not.
No, Dodge does not use inertia/reset switches.
Does not have one.
There is no reset. You have to fix the problem.
The factory alarm does not have a reset button. An aftermarket alarm may have a reset. It could be located wherever the installer put it.
Dodge does not use inertia/reset switches.
The reset button for the fuel pump inertia switch should be DOWN , if the button has popped up there is no power going to the electric fuel pump and the switch needs to be reset by pushing the button down
No. Chrysler does not use reset buttons. The fuel system is controlled with relays.
The rotor button is inside the distributor cap.
my 1996 reset switch is on the far left side of the trunk near the lid. it all black with a red button.
In most cars there is a reset button under the front dashboard on the driver side. If you look under there, it may be well hidden in the wires. It can also be used for valet parking. To reset it I believe you hold it for @ 2 minutes and it will beep a couple of times to reset. Hope this helps
Um, reset button? If you are trying to get rid of the check engine light just unhook the battery cables for a few minutes then hook them back up.
Dodge does not use inertia/seset switches.
Put the key in the door and then lock and unlock it.
the fuel reset button is located to the right of the passengers feet. there is a small plastic panel on the pasenger side just to the front of the passenger door. if you remove that panel you will clearly see the fuel reset button. it is labeled as such. the fuel reset button is located to the right of the passengers feet. there is a small plastic panel on the pasenger side just to the front of the passenger door. if you remove that panel you will clearly see the fuel reset button. it is labeled as such.
Press the trip reset button and keep it depressed while you turn on the ignition. After about 10 sec the oil service warning will reset and you can let go of the button It depends of what model of Polo are you using. If your using a 1995 Polo Classic depress the trip reset button then turn on and off the ignition for 3x then number 1 - 7 will appear choose a number then depress reset button again.