0
What else can I help you with?
What would cause a 1992 wrangler to not have working reverse lights?
Did you check the light bulbs? If OK, probably a bad reverse light switch in tranny.
How do you install a brake light switch for a 1992 Chevy lumina?
It is quite easy to install the 1992 Chevy Lumina brake light switch. The brake light switch simply plugs in and out.
Your 1992 geo storm 5 speed will not shift into reverse please help?
syncros gone.
What do the two 3 pin plugs on the 1992 Dodge Dakota transmission do?
The lower one (sits sideways) is the neutral safety/reverse light switch. The upper one (points down) is for the overdrive and torque converter clutch solenoids.The lower one (sits sideways) is the neutral safety/reverse light switch. The upper one (points down) is for the overdrive and torque converter clutch solenoids.
How do you change the ignition switch on a 1992 g20 Chevy van?
Begin by removing the retaining ring at the top of your 1992 Chevy ignition switch. The ignition switch will slide out. Remove the wiring harness from the end of the ignition switch. Reverse the process to install the new ignition switch.
Where is the Brake Light Switch on a 1992 Dodge 250 Diesel?
the brake light switch is on a bracket just above the brake pedal.
Why would a 1992 Geo Storm 5-speed not shift into reverse?
maybe your transmission is going out or you dont have sufficent transmission fluid.
Where is the backup light switch on a 1992 Toyota pickup?
inside the tranny
Where is the backup light fuse for a 1992 jeep wrangler?
Fuse panel on the drivers kick panel, but your other lights would be out too. What you more likely have there is a reverse/neutral safety switch problem, when out of adjustment the lights will not come on.
What is wrong if the brake light is constantly on in a 1992 crown Victoria?
Normally this is an indication of a defective brake light switch.
Where is the backup light switch on 1992 Nissan 4X4 pickup?
screwed into front of transmission.
Where is the reverse back up light switch located on a 1992 Paseo manual trans with no cruise?
You'll find it after you remove the air filter assembly on top of the trans axle housing. There are only two electrical connectors there. One is the backup light switch the other is a thick ground wire. You'll be able to tell the difference easily. The ground wire is thicker.
