answersLogoWhite

0

The switch is in the gearbox, on the right hand side as you face the engine from the front. There are other senders/sensors on the gearbox. You can identify the switch by lying underneath and removing the two spade terminals, connect them together, with the ignition switched on,your reversing light should now work. You can then eliminate the fault. it may be that the warning light on the dashboard is faulty. The bad news is that a new switch may not solve the problem. The switch is activated by the reverse selector depressing the contact on the switch. This wears over time and eventually does not activate the switch.On my van the problem was only solved when I had the box rebuilt!! Good luck. Paddy the Courier

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

Location of reverse light switch on vauxhall zafira?

where is the location for a vauhall zafira 2004 reversing switch


Where is the reversing light switch on a 2004 Renault laguna?

On a 2004 Renault Laguna, the reversing light switch is typically located on the transmission. It is usually mounted on the gearbox and is activated when the vehicle is shifted into reverse. To access it, you may need to lift the car and remove any protective covers or panels underneath. Always consult the vehicle's service manual for precise location and replacement instructions.


How do you change the brake light switch of an Audi TT 3.2 2004?

To change the brake light switch on a 2004 Audi TT 3.2, first disconnect the negative battery terminal to ensure safety. Locate the brake light switch, which is typically mounted on the brake pedal assembly. Remove the electrical connector from the old switch, then unscrew and remove the switch itself. Install the new switch by reversing the process, ensuring it is securely fastened and reconnect the battery.


Where is the fuse for reversing lights on 2004 citroen xsara?

The fuse for the reversing lights on a 2004 Citroën Xsara is typically located in the fuse box, which is found under the dashboard on the driver's side or in the engine compartment. You should check the owner's manual for the exact location and fuse number, as it can vary by model. If the fuse is intact but the lights are still not working, it may indicate an issue with the wiring or the reversing light switch.


How do you turn the red spanner service light off on a 2004 ford transit van?

turn ignition to position 2..press brake and throttle together for 15 seconds..light will flash..release and switch off...done!


How do you replace the brake light switch on a 2004 Nissan Frontier?

To replace the brake light switch on a 2004 Nissan Frontier, first, disconnect the negative battery terminal to ensure safety. Locate the brake light switch, which is situated above the brake pedal arm; you may need to remove the panel beneath the steering column for better access. Disconnect the electrical connector, unscrew the switch, and install the new switch by reversing the removal process. Finally, reconnect the battery and test the brake lights to ensure everything is functioning properly.


What actors and actresses appeared in Light Rapid Transit - 2004?

The cast of Light Rapid Transit - 2004 includes: Gina Chiarelli as Mrs. Thopson Seth Ranaweera as Hardeep Amber Rothwell as Danika Tygh Runyan as Edward


Why wont your water jets work on ford transit 2004?

Because either there's no water in bottle, or you pressing wrong switch.


Where is the dome light switch on a 2004 Saturn Vue?

On the centre of the ceiling (light for rear section)


How do you change the brake switch in a 2004 ford excursion?

To change the brake switch in a 2004 Ford Excursion, first disconnect the battery to ensure safety. Locate the brake switch, which is typically mounted above the brake pedal. Remove the electrical connector and the mounting screws, then take out the old switch. Install the new switch by reversing the process, securing it in place, and reconnecting the battery.


Where is the fuel cut off switch on a transit van 2004?

In a 2004 transit van, the fuel cutoff switch, also known as the inertia switch, is typically located in the rear cargo area, near the fuel tank. It may be positioned on the right side of the vehicle, close to the wheel well or under a panel. To reset it after a fuel-related issue, you can press the red button on the switch. Always consult the owner’s manual for the exact location and instructions specific to your model.


When was Milton Transit created?

Milton Transit was created in 2004.