They are on top of each cylinder head one on the right one on the left may be gray or blue.
in the rocker arm cover
Remove the valve cover. The rocker arm assembly can be removed by loosening the rocker arm screws. Each rocker arm will have a screw.
Remove a rocker cover and measure one.
On the V6 the PVC valve is located on the drivers side rocker arm cover. Unsure about the I-4, but it should be on the rocker arm cover also.
rocker arm stud is pulling out. how can i get it back in
There is no valve lash adjustment (per se). Torque the rocker arm fulcrum nuts to 23-29 ft. lbs.
There is no torque sequence just torque rocker arm studs to the proper torque
Disconnect the battery negative cable assembly from the battery negative terminal.Remove the spark plug wires.Disconnect the wiring harness from the clips, and move aside.Remove the following components for access to the right valve rocker arm cover:The crankcase vent hose.The oil level indicator tube bracket.The air cleaner intake duct. Refer to Powertrain Management.Remove the following components for access to the left valve rocker arm cover:The air conditioning compressor and lay aside. Refer to Heating and Air Conditioning.The EGR valve inlet pipe.The PCV and the hose.The power brake vacuum pipe and move aside.Remove the valve rocker arm cover bolts.Remove the valve rocker arm cover and the gasket.Clean all traces of old gasket from the valve rocker arm cover and the cylinder head.Inspect the valve rocker arm cover sealing surface for distortion. Replace the valve rocker arm cover if necessary.
For the 1989 Chevy S-10 with the 2.5 liter engine, the torque setting for the rocker arm bolt is 22 ft. lbs. The torque setting for the rocker arm cover is 75-inch lbs.
The function of a rocker arm is to control a valve in an engine. The rocker arm is a lever that rocks.
first you must determine that, it's NOT a rod knock or rocker arm
Remove the have pitman arm seal retaining cover from your 2003 Ford F1 50 pickup truck. The seal will be visible. Use a seal puller to remove the seal.