answersLogoWhite

0

Remove the valve cover. The rocker arm assembly can be removed by loosening the rocker arm screws. Each rocker arm will have a screw.

User Avatar

Wiki User

11y ago

What else can I help you with?

Related Questions

Geo Metro. How do you remove and install hyd lifters 1.3L 95-97?

you must remove the entire rocker arm assembly... inside each rocker is a little button lifter. that's the ones to be replaced... To set the entire rocker assembly back in place, you will need 4-5 hands to squeeze the springs and position the rockers over the valves


How do you remove Headlight assembly on 95 Olds Cutlass Ciera?

The headlight assembly on a 95 Olds Cutlass Ciera is removed by disconnecting the wiring harness and removing the bulb. The assembly can then be unbolted and removed from the vehicle.


How do you remove and install an alternator from a 1999 Acura Integra?

on my 95 i took the driver side tire and brake assembly off to get to it on my 95 i took the driver side tire and brake assembly off to get to it


How do you remove a fender from a 95 dodge ram1500?

There are seven steps on how to remove a fender from a 95 Dodge Ram 1500. Some of the step-by-step instructions are remove the screws that hold the wheel well to the fender, remove the bolts from the wheel well fender, and then remove the bolts that attach the fender to the rocker panel flange.


Where is starter on 95 rx7?

the starter on a 95 RX7 is on the flywheel which is just in front of the clutch, you will need to remove the bell housing around the clutch assembly to get at it however.


How do you remove front light assembly on a 95 Lincoln mark 8?

To remove the front light assembly on a 1995 Lincoln Mark VIII, first, open the hood and locate the retaining screws or bolts securing the assembly. Remove these fasteners, then gently pull the light assembly forward to release it from the clips. Disconnect the wiring harness by pressing the release tab and pulling it away. Finally, take out the assembly completely from the vehicle.


How do you remove the headlamp assembly to replace the bulb on a 95 Honda Passport?

To change the headlight bulb you do not need to remove the headlamp assembly. Pop the hood and behind the assembly is access to the light bulb, just unclip it and carefully pull it out from the hole. Then you can remove the old bulb and put the new one in. Don't touch the light bulb! It won't work if you do.


How do you remove the rocker panel on a 95 Cadillac eldorado?

To remove the rocker panel on a 1995 Cadillac Eldorado, first, raise the vehicle and secure it on jack stands for safety. Then, remove any screws or clips securing the rocker panel, typically found along its length. Use a trim removal tool or screwdriver to gently pry the panel away from the body, being cautious not to damage the surrounding areas. Finally, if needed, disconnect any wiring or components attached to the panel before fully removing it.


What are the torque specks for the rocker arms on a 95 s10 2.2?

The torque specs for a 1995 s-10 rocker arm nut is 22 ft lbs.


Dodge ram 95 4x4 front axle is it possible to remove the axle shaft with out removing the axle nut?

You can take the hub and shaft out at the same time with out removing the nut. just remove the wheel bearing hub assembly bolts (should be three) and then pull the hub assembly out, they will stay together.


How do you replace the wiper switch assembly on a 95 Jetta GL III Washer continues to work wipers don't. Switch arm seems to have resistance when changing positions.?

i had problems in my 95 to but you have to remove the steering wheel in order to get the switch off


Will a 1998 Trans Am headlight assembly fit on a 95 Trans Am?

No it will not the 98 has a different contour than the 95