The select button is on the left side of the middle Xbox button.
there isn't one
Press the sync button once on the xbox and then hold down the sync button at the top of the controller until that controller is connected to the xbox.
there is a tiny button on top of the controller and a depending on what kind of xbox there will be a button on the front of the xbox the slim sill have a more square like button and the first xbox will have a round button but the will have a little illustration on them like this ((( kinda lol but press the controller button on top and then the one on the xbox and it should sync up
The fat one.
You just press the little button on your Xbox 360 and press the one on your controller when it is on
First you go to the top of the controller, right of the left trigger and left of the center of the controller. There is a small round button with a thing that look's like the signal strength of a cell phone above it. Press and hold that till the center button lights start turning clockwise. Then Press the connect button on your xbox. It will then automatically connect the controller to that xbox. Repeat this process if you want to do this on another xbox
If the controller is wired it can be plugged into one of the two usb ports on the front of the console or the one usb port on the back. If the controller is wireless then you must press the small button on top of the controller and the small button on the front of the console to sync them.
You plug it in, in the front of the xbox. It's sort of tricky to get it in but it's not impossible, just frusterating. For a wireless controller there is a little button on the controller and another one on your xbox and you have to push them at the same time so that the controller is activated on that xbox.
Go to your console with your controller. Then there is a button between the two triggers on the controller on the right side. At the same time press that button and the button on the front of the console which looks exactly like the one on the controller.
On the front of the controller there will be a small button on the left side (left if you are holding the remote normally) There will then be a button that looks similar to that one on the console. Make sure the xbox and controller are both on, press and hold the button on the controller, then press and hold the button on the console. If it works, then the controller light will flash 3 times and connect.
The Xbox 360 controller will not work on the Xbox one. You will have to use an Xbox One controller.
It only takes a couple of seconds. When syncing the controller have both your Xbox and controller on. Hold the button on your Xbox (the one to the right of where memory units plug in on the front) and wait until the rings on the console flash, then press the tiny button on the front of your controller between the two bumpers and wait until it syncs with your Xbox.