There is no set button. This information is not listed on the door post of either door. The set function is performed by pressing and holding the preset button. The owner's manual does not provide accurate information on how to set the clock.
1 The set button is the far right button just under the display.Get in your truck and turn the ignition on. Turn the radio off; you can't change the time on the clock if the radio is on.2Press and hold the "Set" button. Press the "Seek" button with the other hand to change the time. If you need to make a large adjustment, hold the "Seek" button and the time will change very quickly. Otherwise, the time will advance by one minute each time you press the "Seek" button (while holding the "Set" button).3Release the "Set" button when you've adjusted the time to your satisfaction. The clock is now set and you can turn the radio on.
Turn radio off. Turn ignition switch on. (engine not running). Pull OUT seek button to change hours. Pull out scan button to change minutes.
With the radio off, press the "set" button. Then press the "scan" button to change the hour and the "seek" button to change the minutes. Once the time is correct press the "set" button once more to change the time.
how do you set the timing on a 1993 Chevy pick up
Chevrolet s10 v6 2.8 liter pickup timing degree, how to set the degree
Hi, I discovered that the HR set button has to be PULLED out and held then the tuning knob used for time set. Same with minute set. To set channels on radio, PULL out the button of choice , Then tune to station and push the button in firmly. There ya go!!!
Press the set button one time. Then to set the hour you press the seek back button to adjust. For the minutes side, you would press seek forward. Then when done press Set again.
You gently pull out the seek button to change the hours and then gently pull out the scan button to change the minutes.
Turn off the radio press set adjust hour with scan button adjust minute with search button
Hold down the "arrow up" button (beside the "audio" button) and it should beep, use the same button for hrs and the "arrow down" button for mins
Turn the radio off. Push the set button until the : blinks. Push scan to change the hours and the seek to change the minutes. When complete, push the set button again and your done.
Hold the button RCL and change the time by pressing up and down on the tune buttons if your car radio doesnt have the RCL buttun use the buttone that changes the view from clock to radio station.