0
What else can I help you with?
How do you adjust the idle on a 1988 ford bronco 2 engine?
by the set screw on throttle cable
Where is and how do you change the throttle sensor on a 1999 Chevy Malibu?
throttle position sensor is located on the throttle body oposite of the throttle cable. Should be held on by 2 screw and a 3 wire plug.
Where is the idle adjustment on a 1984 ford ranger?
There should be a screw near the end of the throttle cable on the throttle body.
Where is the idle screw for a 2003 blaster?
Remove seat and there is a box thing that the throttle cable goes into on the box there is a large screw this is the screw to turn
Where is the idling screw on a 33cc zooma gas powered scooter?
It's the phillips screw where the throttle cable leads into the choke
You have a 2004 Yamaha blaster when fuel is on gas comes out of the over flow tube and what screw adjusts the idle?
your float is stuck in the open or fill position or you need to tighten up the screw you loosened at the bottom of the float cover the idle screw is located near the throttle body that's where the throttle cable meets the carborator
How do i adjust the throttle on the baja mini bike?
There's an adjustment nut on the hand grip for the throttle cable. Back it out to make the throttle tighter, and screw it in for looser.
Where is the idle adjustment screw on a VW Vanagon?
It is a large slotted screw located on the throttle body.
How do you adjust the idle on 1994 4x4 w 22 RE engine?
there is a adjustment screw where the throttle cable attaches to the EFI throttle body.
Where is the idle adjustment screw located on a 1993 Ford Probe?
its located on the throttle body
How to i replace my Throttle position center?
It should be located around the throttle cable at the carbuereator or fuel injection cable on the top center of your motor. Close to where the fuel enters the intake manifold. Basicly a few screws to remove or the module it self should screw off easily according to what your working on.
How does a 1967 Honda ca 160 motorcycle throttle work?
It works like a screw. There is a pin on the inside of the throttle tube that, when the throttle is twisted, moves the throttle bar toward the outside end of the handlebar. The throttle bar has the throttle cable mounted into the end of it, so when it moves, the cable is pulled and the engine revs.
