On a 1995 GMC Sonoma, the speed sensor is typically located on the transmission. Specifically, it can be found mounted on the side of the transmission case, near the output shaft. If you have a manual transmission, the speed sensor may be integrated into the speedometer drive gear. Always consult your vehicle's service manual for precise location and removal instructions.
where is the iat sensor located on a 2003 gmc sonoma truck
were is csp on gmc sonoma 2.2
Where is the timing connector on a 1995 gmc sonoma
The MAP Sensor on the GMC Sonoma is located in the engine compartment just to the left of the alternator. The MAP Sensor is usually colored silver or shows a gold tint.
To locate and change the front speed sensor on a 1998 GMC Sonoma 4X4, first, lift the vehicle and secure it on jack stands for safety. The speed sensor is typically mounted on the front axle housing; trace the wiring harness from the differential to find it. Disconnect the electrical connector, remove the mounting bolt, and pull the sensor out. Install the new sensor by reversing these steps, ensuring the connector is securely attached.
To change a fuel vapor sensor on a 1997 GMC Sonoma you need to disconnect the wires that are holding it in place. Next, remove the old sensor and replace with the new one.
The camshaft sensor is located inside the distributor.
Inside the fuel tank
behind the cat
The 1995 General Motors/GMC Sonoma has the door lock motors and actuator assemblies. These are located in the driver and passenger side doors, behind the door trims.
Coolant Temperature Sensor/Switch (For Computer)Locations View
no spark, no start