It is towards the bottom of the motor on driver's side. three bolts on the starter on and also a clip/connect. It is best to raise/jack the car on driver's side to remove from bottom.
where is the crankshaft sensor located on a 1993 dodge intrepid
Dodge Intrepid was created in 1993.
on the starter its self>>>>JAC
The engine computer is also the voltage regulator.
The positive goes on the large stud. The engine ground wire goes under the center starter bolt.
O,YEA AND I FORGOT TO MENTION IT IS A 1993 DODGE INTREPID...
in the trans
About 18 gallons
Dodge does not use inertia/reset switches.
The horns are under the passenger side of the front bumper. There is a Hi and Lo tone horn.
The 1993 Dodge Intrepid had two OEM tire sizes. The factory fitments for this vehicle were the P205/70/15 and P225/60/16 sizes.
The curb weight of the Dodge Intrepid in 3,318 pounds of 1,505 kilograms. It was produced for model years 1993 until 1997.