Try looking on the side of the left head it should be a one wire sendor, ground that wire to the block if the temp gauge maxs out that means the temp gauge is good.
Where is the oil sending unit at for a 2005 chevy monte carlo
no power at the sending unit.
its on the drivers side of the motor at the front of the motor above the transmission.
There are 2 and they are located on the intake manifold near the thermostat. The 1 with the single wire is for the gauge. The 2 wire is for the cooling fans and the computor. jd
chec the plug in on your sending unit on your gas tank
It should be attached to the fuel pump assembly inside the fuel tank.
Usually, it's near the oil filter. It is on the block just behind the distributor.
Coolant temperature sending unit is located on the front of the engine. The cooling temperature sending unit will be on the right hand side of the engine.
Temperature Gauge Sending Unit The sending unit is located in the front section of the manifold in the vicinity of the thermostat.
On my 2001 there are 3 I think. one by the engine mount on the passenger side. One in each head on the looking up from bottom.
there is an access panel in your trunk underneath the carpet. Undo the top and boom it is sitting right there. Disconnect remove and put new one in.
Sounds like the sending unit in the tank is stuck. It works kind of like the float in your toilet. There is a piece that floats on the top of the fuel and it is attached to a rod that goes to your sending unit. The higher the float, the more gas is shown on the gauge due to the position signal the sending unit is sending out to the fuel gauge. If it is stuck, it probably is best to have it replaced.