It is on the drivers side head.
The 1994 Chevrolet Astro V-6 engine temperature sending unit can be located on the front of the engine. The temperature sending unit will be next to the thermostat housing.
Ground the wire that goes to the temperature sending unit and if the gauge goes up then the sending unit is defective.
There are several sending units in that vehicle such as the fuel sending unit, the oil pressure sending unit, the temperature sending unit. Need to know which one you want to change.
The 1997 Chevrolet Camaro 3.8 liter engine coolant temperature sending unit can be found on the front of the engine. The coolant temperature sending unit will be approximately 3 inches above the thermostat housing.
its screwed in on the front of the water pump
DID U HAVE ANY ParTICULAR SENDING UNIT IN MIND ???
Where is the oil pressure sending unit on 1992 ford ranger
It is in the driverside head between the first 2 spark plugs.
Coolant temperature sending unit is located on the front of the engine. The cooling temperature sending unit will be on the right hand side of the engine.
Temperature Gauge Sending Unit The sending unit is located in the front section of the manifold in the vicinity of the thermostat.
On a 1992 Chevrolet S-10 with a 4.3L V6 engine, the temperature sending unit is located on the engine block, typically near the thermostat housing. It's usually found on the driver's side of the engine, towards the rear, and may be situated near the intake manifold. To access it, you may need to remove any components obstructing the area.
It's located in the thermostst housing just below the thermostat which is tucked under the Throttlebody!