The temperature sending unit on a Ford V10 gas 6.8 liter is on the front of the cylinder head. It is a true sending unit and not just an on and off switch.
Temperature Gauge Sending Unit The sending unit is located in the front section of the manifold in the vicinity of the thermostat.
There is no such thing as a: temperature switch, on your Ford focus, the coolant temperature sensor is located on the front of the engine.
The 1998 Ford Fiesta 1.3 liter engine temperature sending unit can be found on the front of the engine. The temperature sending unit will be near the thermostat housing.
The temperature sending unit on the 1999 Ford Taurus v6 is on the rear of the engine. It is closer to the driver side about 7 inches down.
I am looking for the location of the oil sending switch on a 2000 F150, or where I can see a diagram or picture of it. Thank You
The 1995 Ford F3 50 temperature gauge sending unit can be found on the top of the engine. The temperature gauge sending unit will be near the middle of the intake manifold.
The temperature sending unit it on the front of the engine. It is on the top just beside of the water intake.
The coolant temperature sending units are near the thermostat housing. The small one is for your temperature guage, the larger one is for the EEC system.
Temperature Gauge Sending Unit The sending unit is located in the front section of the manifold in the vicinity of the thermostat.
The temperature sending unit can be checked cold, and then hot, for resistance change. The test is performed with an ohm meter.
yes it has both. at least in my 1991 ford ranger does
Remove the temperature control switch wiring harness. Remove the temperature control switch retaining screws. Reverse the process to install the new temperature control switch.