0
The one for the temperature gauge in the dash is screwed into the drivers side head up front between the first 2 spark plugs.
The one for the computer is screwed into the front of the intake manifold close to the thermostat housing. It is a small one with an electric wire hooked to it.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Can you use headers made for a 5.7L 1996 Chevy k1500 on a 5.0L 1996 Chevy K1500?
Yes thank you very much!
How do you remove the heater core and hoses from 1996 Chevy sub 5.7 k1500?
how do you remove the heater core and hoses from 1996 Chevy sub 5.7 K1500
Will a Chevy transmission from a 1996 k1500 with a 305 V8 fit a 1996 k1500 with a 350 V8 engine?
YES, That is a direct swop.
What is required to change over a 4.3v6 to a 5.2v8 in a 1996 Chevy k1500?
or a 5.7v8
If you can put true daul exhaust on a 5.7L Chevy k1500 can you do the same on a 5.0L Chevy k1500 with out messing up needed back pressure you need good tips for dauling out your 1996 5.0L k1500?
take it to midas muffler
How much does a 1996 Chevy k1500 regcab weight?
How to tell which bank is bank 2
Where is 1996 Chevy K1500 crankshaft sensor?
The crankshaft positioning sensor is located on the bottom of the plastic timing chain cover, right behind the crank shaft pully. It is held in place by a metal clip with a single 10mm bolt.
Where is the coolant temperature sensor on a 1996 Chevy suburban?
To the left of the thermostat housing, It screews into the intake water jacket.
What kind of transmission does my 1996 Chevy silverado k1500 4x4 350 have?
That would be a 4L60E transmission.
What is the 1996 Chevy k1500 350ci ignition timing?
It should be located on a tag under the hood.
Can you replace the stock carburetor on a 1996 Chevy k1500 4.3l v6 with a 4bbl?
The 1996 4.3L engine doesn't have a carburetor, it is fuel injected.
1996 Chevy blazer where is bank 1 Sensor 2?
The bank 1 sensor 2 on a 1996 Chevy Blazer is mounted in the exhaust. Sensor two is just behind the catalytic converter.
