0
What else can I help you with?
Where is the thermostat located on a 1986 Chevy blazer s-10?
follow the upper radiator hose to the thermostat housing on engine. Thermostat is located under the thermostat housing.
Where is the thermostat located on a 1986 VW Golf GTI?
The thermostat for this car is located in the water pump housing from the lower radiator hose.
Do 1990 supra taillights fit on a 1986 supra?
yes .I thank no
Where is the alternator located in a 1986 Toyota Supra?
for real? front of the motor driver side top driven by a belt.
Where is the thermostat located on a 1986 Honda Accord?
The thermostat is almost always located on the top of the engine block, usaully in front of the carberator. Unfortionately, sometimes it is located on the bottom the block
Where is thermostat located on a 1986 Honda Civic?
It is in the big water hose on the in side
What is the difference between a 1986 and a 1987 Toyota supra?
1986 Supra was non turbo and 1987 came in turbo and non turbo.
Where is the thermostat located on a 1986 Toyota Corolla?
Is on the engine block on the upper water hose.
Where is the thermostat located on a 1986 dodge w100 318?
Its on the front of the Intake. Just follow the top radiator hose from the radiator the thermostat housing.
Where is the thermostat located on a 1986 Toyota Celica?
IF YOU FOLLOW THE LOWER RADIATOR HOSE TO THE ENGINE,YOU WILL LOCATE THE THERMOSTAT HOUSING.THERE ARE TWO BOLTS THAT HOLD THE HOUSING ON. THE THERMOSTAT SETS INSIDE THE HOUSING.
Where is the starter located on a 1986 supra?
sitting in your driver seat - it is located directly in front of you up against the firewall. It is very hard to get to but can be seen if you peer down next to the brake cylinder.
Where is theromostat located on a 1986 ElCameo?
On a 1986 El Camino, the thermostat is typically located in the engine compartment, at the end of the upper radiator hose where it connects to the engine. You will need to remove the radiator hose and the thermostat housing to access the thermostat itself. Make sure to drain some coolant before starting this process to avoid spills.
