Follow the upper radiator hose from the radiator to the engine. Where it meets the engine there is the thermostat in the housing. Make sure you install the spring TOWARD the engine when replacing it. GoodluckJOe
if you have a 3.3l v6, then you follow the upper radiator hose to where it connects to the block. It's around the throttle. The place where the hose connects can be removed, and the thermostat is in there.
IF ITS A QUAD 4 THE HOUSING IS ON THE RIGHT SIDE OF THE VALVE COVER BY THE POWER STEERING BELT 2 BOLTS.
The camshaft sensor on a 1993 Pontiac Grand Am is located behind the rear bearing cap. It detects the position of the camshaft as it rotates and relays this information to the computer.
how do i replace a water hose in 1993 pontiac grand am
A 1993 Pontiac Grand Am weighs approximately 2,828 lbs. The Pontiac Grand Am stopped production in the year 2005. The car was replaced with the Pontiac G6.
Make sure the radiator is full of coolant; if it is, then change your engine's thermostat which is located at the lower end of the top radiator hose within the water outlet.
If it is not visible at the door jamb, it is probably located in the latch mechanism
Behind the dashboard just off center.
yes it will pontiacs are interchangable from the years 1993-1996
front of the motor bottom of the block on my 96
Does a 1993 Grand Am have air bags
Follow the upper rad hose from the rad to the engine and at the engine there is a thermostat housing. When replacing the thermostat, make sure the spring goes toward the engine. The thermostat is located under the rad. cap from the top rad hose..