0
Where on a 1993 Pontiac grand am is the door jam switch located?
Wiki User
∙ 16y ago
If it is not visible at the door jamb, it is probably located in the latch mechanism
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
How do you replace the turn signal switch located on a 1993 Pontiac Grand Prix?
My turn signal switch died on my 92 Grand Prix. Rather than attempting the repair, I took it to a shop. The steering column had to be removed to get to the switch.
Power window in 1993 Pontiac grand am won't work?
you probably need a new switch
Where is the camshaft sensor for a 1993 Pontiac Grand Am?
The camshaft sensor on a 1993 Pontiac Grand Am is located behind the rear bearing cap. It detects the position of the camshaft as it rotates and relays this information to the computer.
How much is a water hose for 1993 Pontiac grand am?
how do i replace a water hose in 1993 pontiac grand am
How much does a 1993 Pontiac Grand Am weigh?
A 1993 Pontiac Grand Am weighs approximately 2,828 lbs. The Pontiac Grand Am stopped production in the year 2005. The car was replaced with the Pontiac G6.
Where is the heater core located in a 1993 Pontiac Grand Am SE?
Behind the dashboard just off center.
Will a transmission out of a 1993 Pontiac Grand Am fit in a 1996 Pontiac Grand Pr ix?
yes it will pontiacs are interchangable from the years 1993-1996
Where is the oil filter located on a 1993 Pontiac Grand Prix 3.1L?
front of the motor bottom of the block on my 96
Does a 1993 Pontiac grand am have driver side air bags?
Does a 1993 Grand Am have air bags
Where is the turn signal flasher located on a 1993 Pontiac Grand Prix?
Under the dash in front of the drivers' left knee.
How do you replace the ignition switch on a 1993 Pontiac Grand Am?
It's really easy the switch is in the steering colume.
Where is the blower motor resistor located on a 1993 Pontiac Grand Am?
The blower rheostat on a 93 Pontiac Grand Am is located inside the engine bay, just to the right of the blower fan housing. It is almost directly behind the trans dipstick. It isn't that hard to replace.
