My turn signal switch died on my 92 Grand Prix. Rather than attempting the repair, I took it to a shop. The steering column had to be removed to get to the switch.
To replace a turn signal switch on a 2003 Pontiac Aztek, also known as a flash relay, the steering column must be removed. The flash relay is located under the turn signal. Remove the mounting hardware and the unit can be taken off.
On my 2001 it is part of the Hazard switch. You have to replace the entire switch on a 2001.
The 1991 Pontiac turn signal flasher relay switch can be found beneath the drivers side dashboard. The turn signal flasher relay switch will be above the gas pedal.
To replace the turn signal switch on a Pontiac Transport van, first disconnect the negative battery cable to ensure safety. Remove the steering column covers by unscrewing the screws, then detach the wiring harness connected to the old turn signal switch. Unscrew the switch from the column, replace it with the new switch, reattach the wiring harness, and finally reassemble the steering column covers before reconnecting the battery. Test the turn signals to ensure proper functionality.
Incorporated in the hazard warning module part of the hazard switch
turn signal switch is the hazard button! Pull out hazard button and replace it! good luck!
It's in the hazard warning switch. You need to replace the switch.
The 2003 Chevrolet Silverado turn signal switch is located below the dashboard, on the drivers side of the passenger compartment. The turn signal switch simply plugs in and out.
pull the steering wheel
The turn signal switch is located on the left side of the steering column just behind the steering wheel. It also controls Headlights, Hi/Lo beam and cruise control.
It has been some times since I work on a model close to this. I think you have to remove the steering wheel possibly with a wheel puller. The switch will then be exposed. You disconnect the turn signal switch wiring farther down the steering column by removing a panel. If you look at a new switch, that might help. Larry
Pulling the turn signal switch toward you should switch the lights to the low beams. If that doesn't work, you may have to replace the switch, which means replacing the entire turn signal stalk.