If it has a 4.3L engine the temp sensor is located next to the thermostat housing.
Most likely in the fuel tank.
The starter solenoid is attached to the starter.
On the 4.3L it is located next to the thermostat housing. The electrical plug to it has two wires.
where is the drake light switch on a 1999 chevy s10. The brake light switch is located just above the brake pedal. You will need a flashlight to see it.
Check your heater core and thermostat. The thermostat may be stuck open. Does the S10 run hot or cold?
It goes around the thermostat if you are talking about the Chevy S10 4.3L engine.
Start with replacing the thermostat.
Assuming you have a 195 degree thermostat, it should be aprox 195 degrees plus or minus a few.
1999 S10, it should be under the hood, on the firewall, on the passengers side, close to the blower motor.
there is no thermosat on a 1944 Chevy s10. For that matter there is no 1944 Chevy S10
It should have a 195 degree thermostat.
It is under the thermostat housing located at the engine end of the upper radiator hose.
does anyone know where the horn relay switch is on a 86 chevy S10?
Follow the upper radiator hose from the radiator to the engine. It is attached to the thermostat housing. Removing the thermostat housing will expose the thermostat.
there is an "idler arm", its part of the steering and runs horizontal, as well as a pitman arm
Under the hood, passenger side firewall, near the fan motor.
There is more than one solenoid and they are accessible by dropping the transmission oil pan.
Probably a 195 (F) degree thermostat. That would be what the system is designed for.
The ECM on a 1992 S10 Blazer is located below the glove box.
195 degrees F
You need only to drain off a couple quarts of coolant to change the thermostat.
There is no dip stick just a plug to be removed about 5 inches up on the right side of the trans. If fluid runs out that opoening, it is full. On my 1999 S10 pickup the trans dipstick is located left and in front of the distributor cap (4.3L).
4500 lbs +