0
It is inside the thermostat housing. Follow the lower radiator hose and it will lead you right to it. 3 bolts to remove.
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
What is the firing order for 1995 Ford Aerostar 30L and direction of rotation on distributor?
What is the firing order for 1995 Ford Aerostar 30L and direction of rotation on distributor?"
You have 1990 Ford Aerostar 30L is overheating we had the thermostat replaced recently and it was working fine for a day now it is overheating again Also the heater is not producing any hot air?
Thermostat could be at the tempure setiting, No antiboil antifreeze coolant, and the water leakage or a bad waterpump.
Do all 1994 Ford Ranger 40 have an EGR Valve?
yes 2002 and later 30L are the only ones not equipped with an egr valve
Cylinder Firing sequence '93 Ford Taurus GL 30L?
1-4-2-5-3-6 Distributor rotates clockwise.
How to set timing on 93 Ford Ranger 30L - can't find bolt to loosen distributor?
there should be a clamp right behind the distributor. it will be hard to get to because it is in a hole
Where is the EGR valve on a 1993 Ford Aerostar 30L?
As far as I can tell, there is no EGR valve on 1993 Ford Aerostar 3.0L engines. I have searched and found none and the vacuum hose routing decal in the engine compartment does not show an EGR valve.
What is five sixths of 30litres?
5/6 of 30L is 25L
Where is the knock sensor located on a 1990 Toyota pickup 30L 3VZE?
it's located under the intake manifold. the knock sensor is most likely ok' the porblem is the short wiring harness from sensor to main wire harness.
Can you bring a Military Tactical 30L Backpack to school?
If you can bring a military tactical 30L backpack to school will depend upon the school you are going to. Many schools are now requiring students to wear only clear backpacks, so this backpack would not be allowed.
How do you replace the thermostat located on a 1994 Plymouth Voyager?
Here are the Steps from My [http://www.themotorbookstore.com/caravan.html Manual] REMOVAL & INSTAllATIONThe thermostat is located in a water box at the side of the engine (facing grille) 2.2L and 2.5L engines. The thermostat on 2.6L, 3.0L, 3.3L and 3.8L engines is located in a water box at the timing belt end of the intake manifold. (follow the upper radiator hose) 1. Drain the cooling system to a level below the thermostat.2. Remove the hoses from the thermostat housing.3. Remove the thermostat housing.4. Remove the thermostat and discard the gasket. Clean the gasket surfaces thoroughly.5. Install a new gasket on water box housing 2.2L and 2.5L engines. Center the thermostat in the water box on gasket surface. Install the thermostat housing on gasket. Make sure thermostat sits in its recess of the housing. Tighten bolts to 15 ft. Ibs. (20 Nm).6. On 2.6L engine position gasket on water box. Center thermostat in water box and attached housing. Tighten the bolts to 15 ft. Ibs. (20 Nm).7. On 30L, 33L and 38L engines position thermostat in water box pocket. Make sure thermostat flange in seated properly in flange groove of the water box. Position the new gasket on water box and install housing. Tighten the bolts to 15 ft. Ibs. (20 Nm).8. Connect the radiator hose to the thermostat housing. Tighten the hose clamp to 35 inch Ibs. (4 Nm).9. Fill the cooling system.Good Luck and Remember.Change Your Mind, Not Your Oil.Use the First In Synthetic Motor Oil's.See My Bio For more information.
What size engine was used in 1996 Honda Passport?
it's a 30l, with a dual over head cam...
Can you keep a yabbie in a 30L tank?
Yes you can but it would be adviseable to have a filter, deep substrate and cover glass too.
