answersLogoWhite

0


Best Answer
Copy

where the upper rad hose meets the engine

User Avatar

Wiki User

โˆ™ 2007-10-22 23:38:37
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Add your answer:

Earn +5 pts
Q: Where is the therostat located in a 1993 Mercury Cougar V8?
Write your answer...
Submit

Related Questions

Where is the module located on a 1993 Mercury Cougar?

In the trunk


How do you change water pump on 1993 Mercury Cougar?

how do you change a water pump on 1993 Mercury Cougar


Brake fluid 1993 mercury cougar?

A 1993 Mercury Cougar takes ( DOT 3 brake fliud )


Where is the radiator drain located on a 1993 mercury cougar XR7?

on the bottom of the rad on the passenger side


What type of refrigerant does a 1993 Mercury Cougar use?

What type of freon does a 1993 cougar use


Where is the voltage regulator on 1993 mercury cougar?

embedded with alternator


Where is the fuse box located on 1993 mercury cougar?

Left of stearing wheel, under the dash (get ready for some strange angles!).


What was the original price of a 1993 Mercury Cougar?

the orignial price was $17,890


What is the spark plug gap 1993 Mercury Cougar?

.040 ========================================================== According to one of Fords websites : For a 1993 Mercury Cougar : The 3.8 liter V6 engine and the 5.0 , V8 have spark plugs gapped at : ( .054 inch )


Where is the head gasket located on a 1993 Mercury Cougar?

Between the head and the engine block. under the cylinder head v-* motors have 2 heads and gaskets


Removal of water pump on an 1993 mercury cougar Rx-7?

ok


How do you open the fuel door on a 1993 Mercury Cougar?

A button inside the glove box.


Where is fuel pump located in a 1993 Mercury Cougar?

try going to the local parts house and getting a manual because you will need it when taking down the fuel tank


What is the fuel tank capacity for a 1993 Mercury Cougar?

The fuel tank capacity is 18 gallons


Type of brake fluid 1993 Mercury Cougar?

DOT 3 will work just fine


Where is the thermostat located on a 1993 Mercury Cougar XR7?

Follow the upper radiator hose to the front of the engine. the radiator hose will end up connecting to a metal hose that is attached to the engine. there it is under it.


Where is the coolant temperature sensor located on a 1993 Mercury Topaz?

The coolant temperature sensor on a 1993 Mercury Topaz is located at the rear of the engine. To get to it, you have to remove the driver side fan.


Where is cruise control computer module located at on 1993 mercury villager?

The cruise control computer module is located on the passenger's side of the engine compartment on a 1993 Mercury Villager.


How do you replace lower ball joint on 93 Mercury Cougar?

Remove the tire and wheel from your 1993 Mercury Cougar. Remove the ball joint retaining nut. Pound the ball joint out with a hammer. Reverse the process to install your new ball joint.


How do you drain transmission fluid on a 1993 Mercury Cougar?

Just like all automatic transmission cars, remove the oil pan.


Where is the cruise control module of 1993 Mercury Villager?

The cruise control module of a 1993 Mercury Villager is located under the passenger side of the dashboard.


Where is the tranny located in a 1993 mercury tracer wagon?

The tranny ( or transaxle / transmission ) on a 1993 Mercury Tracer is in the engine compartment bolted to the engine on the drivers side of the engine


How do you take the head light dome light switch off on a 1993 Mercury Cougar?

You don't. The switch is all one , you will have to replace the entire switch.


Is the engine for a 1993 Ford Thunderbird 3.8Lthe same as the engine for a 1994 Mercury Cougar Xr7 3.8L engine?

you can put a 5.0L and everything will be fine!! =]


How do you remove the door panel on a 1993 Mercury Cougar XR7?

To remove the door panel on a 1993 Mercury Cougar XR7, the first thing to do is to remove the lens covers from any lights in the door. The unscrew the light fixtures from the door. The door panel is attached by the use of clips. With a little nudging with a flat object, such as a screw driver, the clips will pop free of the metal.