0
What else can I help you with?
Does a 2001 Isuzu Rodeo V6 engine have a DPFE sensor?
yes it is under the air intake at the throdle body connection one 12mm bolt and 2 hoses.
What could make a 1996 Saturn SL2 chug and run rough even after changing the EGR valve?
Could be alot of things. Here's a few that i suggest to ck out. 1. Clogged cataletic convertor. 2. need a tune-up 3. TPS sensor (Throdle position sensor) 4. MAP sensor
Picture of location of thermostat on a 2004 Chevrolet Malibu classic?
i just changed mine in my 98 3.1 if you remove the throdle body you can get to the bolts it is jery easy
How do you change starter button on 1996 Honda magna?
changing starter button on 1996 honda magna 750 how to remove throdle cables from from hand grip.
2003 Chrysler Sebring idle has increased to aprox. 1500 rpm. Would the problem be with the idle control valve Where is valve located?
It is located just above the dist below the throdle body. On a 3.0 2.7 about the same
Why is car engine bucking with warning light on?
I took my car to change the oil and after that the check engine light came on and the car bucked at low speed. I finally found that the large tube that went from the air filter to the throdle body had a large crack in it and was causing the problem. I did a code scan on my 1994 Lexus es300 and it showed that a O2 sensor was bad but the new hosefixed the problem. if the hose is ok Iwould check to see if there are any vacuum laks in that area.
My Yamaha Blaster wont idle?
under the seat where the throdle screws in the carb, there is an adjustment screw, turn right and it increases the idle. it worked for me. do it while running. It is a large flat head screw that is on the throttle body control mechanism. Not on the carburetor itself.
Is image sensor a MEMS sensor?
No, the image sensor is not a MEMS flow sensor as many think.
Is a map sensor the same as a throttle position sensor?
No map sensor is manifold absolute pressure sensor and tps throttle position sensor
Where is oxygen sensor 2 on 2001 dodge ram 1500?
Bank 1 sensor 2 is the sensor after the catalytic converterBank 1 sensor 2 is the sensor after the catalytic converter
What makes a 1990 Honda Accord EX rev up and down while in park or netural or when coming to a stop?
AnswerSeveral things can cause this. Take it to a garage. AnswerCHECK YOUR AIR FILTER, ALSO COULD BE A AIR LEAK, ALSO MAKE SURE THE SCREW ON THE THRODLE BODY IS NOT LOOSE...MEANING TO SAY U MIGHT BE LETTING TOO MUCH AIR INTO THE THRODLE BODY, THERE IS A SCREW TO ADJUST IT MAKE SURE ITS NOT OPEN TOO BIG. my 93 does the same thing. check the coolant level. this is usually the culprit. the only other thing i can think of with this model is the tps. "throttle position sensor" is shorting out. a couple other things these cars are known for are the notorious "main relay" shorts out and the car wont start when its hot. replacing this relay will be an absolute must eventually. and the ignition module inside the distributor assembly. yeah, theyre pricey$$$ but replace with oem or better. buying a cheapy will just leave you stuck somewhere wondering why you replaced it with a piece of crap. but back to the reving.... its probably your coolant level.
Is a knock sensor the same as an af sensor?
No, it is not a knock sensor at all. An AF (Air/Fuel Ratio) sensor is also know as a wide range oxygen sensor. It is the newer type oxygen sensor.
