Best Answer

The 1993 Chevy Lumina 3.1 liter engine timing belt can be found on the front of the engine. You will need to remove the front engine cover in order to access the timing belt.

User Avatar

Wiki User

โˆ™ 2014-11-19 22:55:55
This answer is:
User Avatar
Study guides

Add your answer:

Earn +20 pts
Q: Where is the timing chainbelt on a 93 Chevy lumina 3.1 v6?
Write your answer...
Still have questions?
magnify glass
Related questions

Does a 1990 Chevy Lumina V6 31 get green or orange antifreeze?


Where in the fuel tank is the pump located on a 1991 Chevy Lumina 31?

Mounted on top of the tank.

Where is the heater fan loctaed on a Chevy Lumina Euro 31 -91?

It is located on the firewall right behind carborator.

Where ia the radiator drain plug located on a 91 Chevy lumina 31?

facing the car it is on the bottom right side. Turn the vavlve counter clockwise and pull out.

Where are the three oxygen sensors located on a 1996 Chevrolet Lumina 31?

where is the oxygen sensor located on a 1997 Chevrolet lumina

Where is the A C recharge fitting on a 1990 31 liter V 6 Chevy Lumina?

It should be under the air filter, which needs to be removed temporarily to access the low(blue) charge valve.

Where is the oil sending unit on a 93 lumina 31?

On the bottom/back of the engine

How do you install a fuelpump on a 92 31 liter Chevy Lumina?

It is located in the fuel tank. Unless there is an access panel in the trunk or under the rear seat, the tank must be removed in order to install the pump.

What is the firing order for a 31 liter 2000 Chevy lumina and what is the cylinder numbers from front of car?

the firing order will be located on the intake usually the aluminum part of the engine on the top you may need a lite to seeit

How do you reset the computer for a 1993 Chevy Lumina?

Had that problem once and i was told to drive my car 30 miles without having to stop at any stop lights or any signs . Did this and mine fixed itself at 31 is a 3.1 engine.

What size gas tank does a 2004 Chevy suburban have?

31 Gallons

What would cause a cylinder in a 98 lumina 31 have no compression it sucks insted of blows?

Maybe a bad valve

People also asked