on the front of the engine behind water pump (water pump is bolted to it )
The timing marks on a 1994 Toyota Corolla are located on the crankshaft cover. The crankshaft cover is usually located at the very bottom of an engine.
On a 1986 Mazda B2000 pickup, the timing marks are typically located on the crankshaft pulley and the timing cover. You should see a mark on the crankshaft pulley aligned with a corresponding mark or scale on the timing cover. To check the timing, you may need to remove the inspection plug on the timing cover to view the marks clearly. Always refer to the specific service manual for detailed procedures and specifications.
To set the timing on a 1990 Toyota pickup, first, ensure the engine is at operating temperature and then turn it off. Locate the timing marks on the crankshaft pulley and the timing cover. Use a timing light connected to the number one cylinder spark plug wire, and adjust the distributor until the timing mark aligns with the specified degree mark on the timing cover. Finally, recheck the timing after tightening the distributor to ensure it hasn't moved.
It is behind the timing case cover behind the crankshaft pulley.You have to remove the timing belt to replace the water pump for this repair.
It is on the left front side of timing cover behind the balancer.
It is bolted in the passenger side of the timing cover, Behind the harmonic balancer.
It's on the valve cover
Under the left side cam under the timing belt cover
The Thermostat is located to the pasenger side of the Valve cover, just folow your upper radiator hose back and it will be in the housing that the hose conects too.
Yes , it has a timing CHAIN
Near the bottom timing belt cover (on the top left).
smack in the middle of the valve cover