It doesn't have one. You have to remove the transmission pan to drain.
NO! Don't even think about it!
You have to remove the pan to drain the transmission.You have to remove the pan to drain the transmission.
A 2006 Chrysler Pacifica with a 3.5L V6 and front-wheel drive (FWD) uses Automatic Transmission Fluid (ATF) type MS-9602. The transmission fluid capacity for this vehicle is approximately 7.5 quarts
A ( 2004 to 2006 ) Chrysler Pacifica 3.5 litre V6 engine has a timing BELT A ( 2006 to 2008 ) Chrysler Pacifica 3.8 litre V6 engine has a timing CHAIN A ( 2007 and 2008 ) Chrysler Pacifica 4.0 litre V6 has a timing BELT
What type of oil does chrysler pacifica take
Yes
10w3010w30
To replace the spare tire on a 2006 Chrysler Pacifica you will need to use the wire to hoist up the tire and use the lug wrench to hold it back into place.
To change the transmission fluid in a 2006 Chrysler Pacifica, first ensure the vehicle is on a level surface and securely raise it using jack stands. Remove the transmission pan bolts and carefully lower the pan to drain the old fluid. Replace the transmission filter, clean the pan, and install a new gasket. Finally, refill the transmission with the appropriate fluid through the dipstick tube, ensuring the fluid level is correct after running the engine and shifting through the gears.
ATFATF
Underneath the rear, behind the axle.
Red, 5 year, HOAT type.