0
What else can I help you with?
Where does transmission fluid on 97 rodeo go?
My 1998 Rodeo transmission fluid is filled, by removing a filler nut on one side of the transmission (from below) .. with the other filler nut removed on the other side. When the fluid flows out, it is full. This is what a local service station told me. For a few years Rodeo's did not have a filler in the engine compartment.
What type of gearbox does a 1985 Holden rodeo KB Ute have?
Manual or Automatic.
When was Holden Rodeo created?
Holden Rodeo was created in 1980.
What Manual transmission came in 1995 Isuzu Rodeo?
The manual transmission that came in 1995 Isuzu Rodeo was 21.9 US gallon engine which was ranked as 18mpg-US. This has been modified over the years with most models having automatic transmission.?æ
Will a manual transmission for a 92 Isuzu rodeo fit a 95?
Yes if the engine's are the same
What is compression on the cylinders of 2001 Holden rodeo diesel 2.8lt?
The compression on the cylinders of a 2001 Holden Rodeo diesel 2.8lt is not stated. It is stated that the 2001 Holden Rodeo diesel 2.8lt has a high compression g200z motor.
What is the transmission fluid for a 1998 Isuzu Rodeo?
I own a 1998(automatic) 3.2L V6 4x4 Rodeo,and I follow the service manual which says to use DEXRON II auto transmission fluid.
Where can one find a used Holden Rodeo 4x4?
One can find a used Holden Rodeo 4x4 at a local used car retailer. Alternatively, one can try looking for a used Holden Rodeo 4x4 for sale online on Craiglist.
How do you remove a Holden radio?
What model mate? A 2007 LX 4X4 Holden Rodeo
How do you tighten front bearing on 05 Rodeo?
Need to know which bearing and which Rodeo. There is a Isuzu Rodeo and a Holden Rodeo. Each has several bearings.
Will holden rodeo wheel fit a VW amarok?
No.
How do i replace clutch in a holden rodeo 4x4 turbo diesel?
To replace the clutch in a Holden Rodeo 4x4 Turbo Diesel, start by safely lifting the vehicle and removing the transmission. Disconnect the battery and drain the transmission fluid. Then, remove the clutch assembly, including the pressure plate and release bearing. Install the new clutch by aligning it properly with the flywheel, reattach the pressure plate, and reverse the disassembly steps to reassemble the transmission and reconnect all components.
