It should be equipped with both.
Mitsubishi Galant, 2002, 4-cyl, O2 sensor, bank 1 sensor 1 (upstream)... PART NUMBER: MR506364
Both before and after.
Where is the crank position sensor 0n a 2001 mitsubishi Galant
where is bank1 sensor2 on the 1999 Mitsubishi montery sport 3.5
It's on the exhaust manifold right under your hood, at least it is in my 2000 Galant 2.4 L.
no. the upstream sensor is the one before the catalytic converter and the downstream is the one after
There are two oxygen sensor for Mitsubishi Outlander. Front Oxygen Sensor and Rear Oxygen Sensor
Its in the distributor
the speed sensor for 2004 Mitsubishi Galant is located on the front case of the transmission output shaft and speed sensor. It is approximately under the hood to the left of the engine.
Can you show me a diagram of the upstream oxygen sensor on a 3.5l liter Oldsmobile Intrigue engine?
where is an oxygen sensor in 2000 mitsubishi pajero io
Right upstream oxygen sensor heater failure.Right upstream oxygen sensor heater failure.
its the 1 on the exhaust manifold pointing out towards the front of the car. i just replaced it on mine
P0135 on Mitsubishi galant 2003 Definition: HO2S 11 Heater condition (Heated Oxygen Sensor Bank 1 Sensor 1) Explanation: The powertrain control module monitors the oxygen sensor heater. The computer has recognized a failure in this ciricuit. Probable Causes 1. -Oxygen sensor defective 2. -Poor connection at oxygen sensor 3. -Check circuit-fuse
Inside the distributor
where is the oxygem sensor on 1996 Mitsubishi mirage
Where can I find the camshaft sensor for my car 2002 mitubishi galant es 4 clyinder
Which one? Upstream or downstream?
The upstream oxygen sensor is mounted in the exhaust manifold The downstream oxygen sensor is mountedin the exhaust pipe after catalytic converter
it should be the bank facing the front of the car in the manifold. you should be able to find it right in front when open the hood
on the front side of the throttle body.
The upstream heated oxygen sensor is located ahead of the catalytic converter The downstream heated oxygen sensor is located behind the converter
The upstream oxygen sensor is mounted in the exhaust manifold The downstream oxygen sensor is mounted in the exhaust pipe after the catalytic converter