Passanger side of intake on side of intake
The plenum is the intake manifold.
The Kia Sedona is standard configuration gasoline engine. The fuel injectors are located at the top of the engine area and provisioned into the intake manifold/cylinder head assemblies.
They Are under the Intake manifold like on my 04 kia sedona, You have to removethe center part of the manifold.
where is the knock sensor on 2003 kia Sedona answer knock sensor is mounted on the engine block near the intake manifold with a wiring harness attached to it.
There are 3 in the front, but the other three, you have to take the intake manifold OFF the car,,, big job. Bob in AZ
You have to remove the intake manifold to get to the 3 rear ones. Search this forum, this question has been answered at length with full description of step by step method.
In my sportage I had to remove the intake manifold off to get at them (all 4) home it helps.
a temp sensor is located on the intake or the thermostat housing
The Sedona Mountains are located in Sedona, AZ.
A camshaft position sensor detects which cylinder is firing and establishes the coil firing sequence. In a Kia Sedona, it is located at the end of the intake camshaft.
It cost me over $450 at the dealer. This is due to the fact that they must remove the intake manifold to access the back 3 plugs.
There is a black plastic cap to the right of the manifold (or to the left of the battery). It has a plastic bolt on the top of the cap. Very difficult to get off.