There isn't a vehicle speed signal wire on a 2007 Sebring. The transmission computer uses its input and output sensors to factor vehicle speed. It then transmits that message over the communication wires of the vehicle.
VSS (Vehicle Speed Sensor) failure.
Goes from the VSS to the ECM. Find the VSS, and you can trace it from there.
the vss wire is located as the purple/white wire above the radio, the harness plugging into the clock. tap into the purple/white wire for your aftermarket headunit vss wire.
on the automatic transition and PMC (vehicle computer) blue with white wire (wire A30 VSP - vehicle speed pulse)
check the windshield washer motor like on the 2007 ford explorer and expedition and most pickup's.
http://www.kiatechinfo.com
if you can tell me where the VSS wire is located,say brake module, radio etc. i have complete wiring diagram that's 15 pages long,and can track it.
Computer
there isn't a speed pulse on the new dodge vehicles, you have to use an aftermarket gererator. like the soundgate CAN VSS works via the CAN system
ford vss wire locationif the harness is similar to 02 ranger look behnd radio to the left there is a module the grey/black is the vss also if your vehicles radio volume automaticaly increases with the speed of your vehicle then the wire will also be located in your radio harness hope this helps>>>>> Jim t
normally its the yellow/red wire. you can find it underthe hood in the wire harness right above your fan.
It attaches to VSS on tranny by where it meets driveshaft.