under back seat
Under the timing belt cover. It is driven by the timing belt.
water pump, or coolant pump, is located just above the crankshaft pulley. It attaches to the power steering pump as well. If you are facing your engine it will be behind the alternator, above the crankshaft pulley, attached to the timing belt cover.
For a 2006 Hyundai Tiburon, the recommended antifreeze is a mixture of ethylene glycol-based coolant that meets the specifications of SAE J1034 and is typically a 50/50 mix with distilled water. Hyundai recommends using their Genuine Antifreeze/Coolant, which is a phosphate-free formulation. Always check the owner’s manual for specific requirements and recommendations regarding coolant types and mixtures.
I have a 2006 Hyundai tiburon. I have the same problem. Had the computer module changed but it continues to happen. The dealer says that water is getting in the motor and causing it to stop. That is not acceptable
looking st the engine...it's under the shroud to your left. the larger belt. it is there with the power steering, water pump and alternator.
where do you find the water pump in a 1999 sonato hyundai.
The Hyundai Tiburon typically requires about 7.5 to 8 quarts of coolant when performing a complete coolant change. Always refer to the owner's manual for the exact specifications and recommended coolant type for your specific model year. Ensure the coolant mixture is appropriately diluted with water, usually a 50/50 ratio, unless otherwise specified. Always check the coolant level after filling to ensure it reaches the proper mark.
The drain cock on a Hyundai Tiburon is typically located on the engine block, usually towards the bottom of the radiator or near the water pump. It's a small valve or plug that allows for draining the coolant from the system. For precise location, it’s advisable to consult the owner’s manual or a service manual specific to your model year. Always ensure the engine is cool before attempting to locate or operate the drain cock.
you have to remove the belts and water pump pulley the water pump is located behind the timing cover.
Drill a hole through the drivers side firewall near (if it's a M/T) the slave cylinder reservoir. Feed the wire through (it will be located near the clutch pedal - if M/T) and cover the exterior with wire lume or epoxy to prevent water from coming in
it is under the timing cover and it is quite hard
How to change a water pump on a 94 hyundai scoupe?